Just like the original OctoGrab™ Magnetic Flex Bed enjoy the convenience of removing prints without bed scrapers. Simply remove the textured flexible top sheet, flex, and prints slide right off! The new textured powder coated PEI has more grip than standard laminate PEI, adhering prints much easier. This powder coating is more durable and resilient, lasting you longer.
Quick & Easy Upgrade
Upgrading is easy.
If your LulzBot Mini 1 or Mini 2 already has a LulzBot Mini Modular Print Bed System installed, this upgrade simply replaces your Glass/PEI Print Surface. If you do not already have the Mini Etched Modular Print Bed Heater you must also purchase one with your Textured OctoGrab™ Magnetic Flex Bed.
Not compatible if your Mini 1 is version 1.03 or has a serial number of KT-PR0035NA-7499 or lower.
To upgrade, simply remove the four bed leveling washers and existing glass/PEI bed from your Mini Etched Modular Print Bed Heater equipped Mini 1 or 2. Insert the OctoGrab™ aluminum magnetic base on top of the Mini Etched Modular Print Bed Heater and replace your bed leveling washers.
Important: Adjust your Z offset to the new print surface and start printing!
After prolonged use, you may need to clean your OctoGrab™ surface with a 50/50 mix of isopropyl alcohol and water to renew its adhesion abilities. Allow the surface to dry completely before printing.
bed surface dimensions: 170mm x 170mm
Works with the Mini Etched Modular Bed Heater
Spring steel with powder coated PEI
Octograb was derived from work by Tim Pierce in the LulzBot community.
Choose options